Mail: cannot send message: Process exited with a non-zero status Hence I looked into the Postfix error log file i.e. Emails notifications were configured through using my Gmail account.Īfter a while one of the cron job failed but I did not get any email notifications. Since it is very important for me to be notified whenever a cron job fails, I had setup email notifications. On my test server I have few cron jobs which fetch data from various sources. Repair fees might apply for out-of-warranty products.Mac for cheap. If out of warranty, locate a Brother Authorized Service Center. If in warranty, contact Brother Customer Support or locate a Brother Authorized Service Center to schedule product replacement or repair. If the error does not return, discontinue troubleshooting.Ĭheck the warranty status of your machine by clicking on the Machine Warranty Calculator. Test again by pressing MENU, 4 (Printer), 2 (Print Options), 2 (Configuration). Network setup will need to be performed.Ħ. NOTE: Resetting the machine settings will also rest the network setting. If the message 'Size Mismatch' appears, reset all settings to the factory default by pressing MENU, 6 (Initial Setup), 3 (All Settings), 1 (Reset), 1 (Yes). To test, print the Printer Settings by pressing MENU, 6 (Print Reports), 5 (Network Config). Press the UP OR DOWN ARROW key to select an appropriate tray priority list and then press OK.Ĥ. The tray that is being used should be the first or only tray listed in the tray priority list. The tray priority list assigned to the selected function will be highlighted with an asterisk (*) next to it. Press MENU, 1 (General Setup), 6 (Tray Use), 2 (Fax).ī. Verify that the correct tray is assigned to the FAX function:Ī.
If the assigned paper size does not match the size of the paper loaded in the tray, press the UP OR DOWN ARROW key to select the correct paper size and then press OK.ģ. The paper size assigned to the selected tray will be highlighted with an asterisk (*) next to it. NOTE: Tray #2 will only appear if the optional lower tray is installed.ĭ. Press the UP OR DOWN ARROW key to select 'MP Tray', 'Tray #1', or 'Tray #2'. Press MENU, 1 (General Setup), 2 (Paper), 2 (Paper Size).ī. Verify that the paper size setting for the tray matches the paper size that is loaded:Ī. If the guides are pushed too tightly against the edges of the paper, the paper may be unable to feed properly.Ģ. They should be set to the positions marked for the paper size that will be loaded into the tray. NOTE: Make sure that the guides do NOT push tightly against the paper. The release lever for the rear guide is in the middle of the rear guide.
The release lever for the left and right guides is located at the middle of the right guide. It will be necessary to hold the release levers (1) when moving the guides to a larger size. Remove the paper from the tray and set the paper guides to the correct paper size. Verify that the paper size loaded in the tray:ī. This will also appear if the size of the paper set in Tray 1, Tray 2, or the MP tray does not match the size specified in the printer driver.ġ. The message 'Size Mismatch' will appear if the paper loaded in the paper tray is smaller than letter size (8.5 x 11 inches) when printing received faxes or printing one of the Brother machine's internal reports.